cherrylmka.blogg.se - Automatic PDF Processor 1.25 for mac instal

Note: Calibrating your label printer is only necessary when you insert a new label roll of a different size. The printer will measure and feed a few blank labels. To do so, hold down the pause and cancel buttons for two seconds and release. This will make sure that your labels will print correctly. Push the lid closed until both yellow latches snap shut.įor your label printer to recognize the size of your labels, you need to calibrate it.Flip the labels up and align the movable sensor to the center position.Pull the labels out past the cutter at the front of the printer.Make sure the label roll is secure and turning freely.

Release the roll guides and push them together.

Pull the yellow roll guides apart and insert the label roll with the labels facing upwards.

Pull the yellow latches on both sides of the printer towards you and lift the printer's lid open.

Label rolls are purchased separately from your label printer. Connect the other end of the USB cable to your computer.

Connect one end of the USB cable to your label printer.Connect the power cord to the power supply and an electrical outlet.Connect the power supply to the back of your label printer.To connect your label printer, you need the power cable, the power adapter, and the USB cable. Note: You’ll receive an email in your inbox as soon as your hardware shipment has shipped. If you have further questions regarding your shipment, please contact the shipping carrier or Billing.